Vehicle Diagnosis Tester, Connecting And Checking
WARNING: This page is about a different variant/trim than selected.
Special tools and workshop equipment required
- Vehicle Diagnosis Tester
WARNING:
To prevent possible injury when performing measuring tests or test drives, always refer to SAFETY PRECAUTIONS .
-- Connect the vehicle diagnosis tester with the ignition on the Data Link connector (DLC) turned off.
Installed location: Front left footwell, near hood opener.
Starting "Guided Fault Finding" :
-- Turn on the ignition.
-- Touch "Guided Fault Finding" on the screen.
-- Select the following in this sequence:
- Brand
- Type
- Model year
- Version
- Engine code
-- Confirm the information entered.
-- Wait until the test has checked all control modules in the vehicle and has produced a testing plan.
-- Follow the test plan.