Driveshaft Overview
WARNING: This page is about a different variant/trim than selected.
NOTE:
Do not perform any service work on the driveshaft.
- Transmission with Bevel Gear
- Bolt
- 60 Nm
- For attaching the driveshaft to the bevel box
- Driveshaft
- Cannot be separated at the joint -arrow-
- Removing and installing, refer to DRIVESHAFT WITH INSEPARABLE CENTER SUPPORT, FROM 05.07, REMOVING
- Bolt
- 25 Nm
- Intermediate Bearing
- Align without tension
- Bolt
- 50 Nm plus an additional 90° turn
- Always replace
- For the rear flexible disc on the driveshaft
- Bolt
- 60 Nm
- For flexible disc to final drive
- Flexible Disc with Vibration Damper
- Heat shield faces the driveshaft
- Rear Final Drive
- Removing and installing, refer to REAR FINAL DRIVE