Rear lights in rear lid, removing and installing
Removing
CAUTION:
- Switch off all electrical components.
- Switch ignition off and remove ignition key.
- Turn light switch into "0" position.
- Open cap - 1 - for warning triangle.
- Rotate quick-release screw - 2 - counter-clockwise 90 ° and remove cover - 3 - from luggage compartment lining - direction of arrow -.
- Disconnect electrical harness connector.
- Remove bulb socket - 1 - from housing, press catch bracket - 2 - downward - arrow - to do so.
- Unscrew nut - 2 - and remove clamping bracket - 1 -.
- Remove nut - 4 - and remove inner tail lamp - 3 - toward outside.
- Remove clamp mounting - 5 - from body cut-out.
Installing
Installation is the reverse of removal, noting the following:
NOTE:
- Make sure seal between body and tail lamp housing seals properly.
- Attach clamp mounting - 2 - at inner tail lamp and screw on nut - 3 - loosely.
- Attach inner tail lamp - 4 - at body cut-out and make sure grip tabs - arrows - of clamp mounting rest against body cut-out.
- Slide clamp mounting - 1 - onto threaded pin of inner tail lamp and tighten nuts - 3 - and - 5 -.
NOTE:
- By tightening nut, clamp mounting wedges with inner interior light and rear lid.
Tightening torques
| Component | Nm |
| Clamp mounting to housing | 3.5 |
| Clamping bracket to body | 3.5 |