Input Shaft Seal, A4 And A5, From My 2008, Transmission Series Number 000761

Special tools and workshop equipment required 

• Pulling Hook T20143/1
• Thrust Piece T40174
• Sealing grease G 052 128 A1

• Transmission is removed, refer to [For engine(s) CAUA] Removal and Installation .

-- Remove the clutch module. Refer to CLUTCH MODULE .

-- Pry out the input shaft seal.

Fig 1: Removing Input Shaft Seal

Courtesy of AUDI OF AMERICA, LLC

-- Lightly coat the outer circumference of the new shaft seal with oil.

Fig 2: Installing Shaft Seal

Courtesy of AUDI OF AMERICA, LLC

-- Fill the space between the sealing and dust lip half way with sealing grease G 052 128 A1.

-- Install the shaft seal all the way. Be careful not to bend it.

-- Install the clutch module. Refer to INSTALLING .