Overview - End Cover

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2016 Audi A4, 2015 Audi A4, 2014 Audi A4, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Danger of causing damage to the transmission.

Do not let the engine run or tow the vehicle when the cover is removed or when there is no ATF in the transmission.

NOTE:

General Repair Instructions. Refer to GENERAL REPAIR INFORMATION .

Clean working conditions for the automatic transmission. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

Fig 1: Overview Of End Cover, Transmission Control Module And Hydraulic Control Unit Overview

Courtesy of AUDI OF AMERICA, LLC

Transmission
Small Axial Sealing Element
- Replacing
Large Axial Sealing Element
- Replacing
Roller
Selector Lever Lock Mechanism Lever
Spring
Seal
- For the connector on the Transmission Control Module -J217-
Bolt
- Tightening specification. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
Cover
- Removing and installing. Refer to END COVER, REMOVING AND INSTALLING .
Seal
- Replacing
Bolt
- Tightening specification. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
Transmission Control Module -J217-
- Removing and installing. Refer to TRANSMISSION CONTROL MODULE, REMOVING AND INSTALLING .
Bolt
- Tightening specification. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
Hydraulic Control Unit
- Removing and installing. Refer to HYDRAULIC CONTROL MODULE, REMOVING AND INSTALLING .