Overview - End Cover

WARNING: This page is about a different car, the 2014 Audi A5, 2013 Audi A5, 2012 Audi A5, and 2011 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Danger of causing damage to the transmission.

Do not let the engine run or tow the vehicle when the cover is removed or when there is no ATF in the transmission.

NOTE:

General Repair Instructions. Refer to GENERAL REPAIR INFORMATION .

Clean working conditions for the automatic transmission. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

Courtesy of AUDI OF AMERICA, LLC

Transmission
Small Axial Sealing Element
- Always replace
Large Axial Sealing Element
- Always replace
Roller
Selector Lever Lock Mechanism Lever
Spring
Seal
- For the connector on the Transmission Control Module -J217-
Bolt
- Tightening specification. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
Cover
- Removing and installing. Refer to END COVER, REMOVING AND INSTALLING .
Seal
- Always replace
Bolt
- Tightening specification. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
Transmission Control Module -J217-
- Removing and installing. Refer to TRANSMISSION CONTROL MODULE, REMOVING AND INSTALLING .
Bolt
- Tightening specification. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
Hydraulic Control Unit
- Removing and installing. Refer to HYDRAULIC CONTROL MODULE, REMOVING AND INSTALLING .