Overview - Timing Chain Cover: Notes
- Bolt
- Tightening Specification and sequence. Refer to Figure.
- Crankshaft Shaft Seal, Transmission Side
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .
- Alignment Sleeve
- Quantity: 2
- Lower Timing Chain Cover
- Removing and installing. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .
- Left Cylinder Head Gasket
- Bracket
- For the electrical wiring harness
- Bolts
- Tightening Specification and sequence. Refer to Figure.
- Bracket
- For the left oxygen sensors electrical connectors
- Left Timing Chain Cover
- Removing and installing. Refer to LEFT TIMING CHAIN COVER, REMOVING AND INSTALLING .
- O-ring
- Always replace
- Left Coolant Intermediate Pipe
- Remove using a drift
- O-ring
- Always replace
- Bolt
- Tightening Specification and sequence. Refer to Figure.
- Bracket
- For the right oxygen sensors electrical connectors
- O-rings
- Always replace
- Right Coolant Intermediate Pipe
- Remove using a drift
- Right Timing Chain Cover
Removing and installing. Refer to RIGHT TIMING CHAIN COVER, REMOVING AND INSTALLING .
- Right Cylinder Head Gasket
- Alignment Sleeve
- Quantity: 2
- Engine Speed Sensor -G28-
- Removing and installing. Refer to ENGINE SPEED SENSOR -G28-, REMOVING AND INSTALLING .
- Bolt
- Tightening Specification. Refer to OVERVIEW - IGNITION SYSTEM .