-- Tighten The Camshaft Adjuster Bolts On The Right Cylinder Head As Follows:

Step	Bolt	Tightening Specification
2.	-1- to the intake camshaft	Final Tightening Specification
2.	-2- to the exhaust camshaft	Final Tightening Specification

-- Remove the :3242  .

-- Turn the crankshaft 2 turn in direction of engine rotation in direction of -arrow- until the crankshaft is at "TDC" again.

• The threaded holes -arrows- in the camshafts must face upward.
  Fig 4: Facing Threaded Holes In Camshafts Upward (As Shown)

  Courtesy of AUDI OF AMERICA, LLC

-- :T40070  mounted on both cylinder heads and tightened to 25 Nm -arrows-.

• The :T40070  is correctly positioned when the holes for the cylinder head bolts remain free.

-- Install the :T40237  in the hole and tighten to 20 Nm.

• The :T40237  must engage in the locating hole in the crankshaft -1-, otherwise repeat the adjustment.

-- Remove the camshaft locating pins on both cylinder heads.

-- Remove the :3242  .

-- Install the sealing plug -arrow- for the "TDC" marking in the upper part of the oil pan. Refer to OVERVIEW - OIL PAN UPPER SECTION .

Install in reverse order of removal. Note The Following: 

-- Install the timing chain covers. Left, refer to LEFT TIMING CHAIN COVER, REMOVING AND INSTALLING . Right, refer to RIGHT TIMING CHAIN COVER, REMOVING AND INSTALLING .

-- Install the cylinder head covers. Left, refer to LEFT CYLINDER HEAD COVER, REMOVING AND INSTALLING . Right, refer to RIGHT CYLINDER HEAD COVER, REMOVING AND INSTALLING .