Seat Belt For Child Seat, Checking Child Seat Restraint Function, Market-Specific

To Check Function, You Must Install Entire Belt System, including Side Trim.

Switching Hold Function On 

• Pull Belt Webbing Out Completely Up To Stop.

Correct Function 

• Belt Must Retract With A Chattering Sound.
• If Retracting Process Is Stopped, Belt Cannot Be Pulled Out Anymore.

Deactivating 

• Belt Retraction To About 100 mm Remaining.
• Hold Function Must Switch Off With A Remainder Of 100 mm, At The Latest. Belt Functions Normally Again.

• If The Seat Belt Child Seat Anchorage Does Not Work, Replace The Seat Belt