Requirements To Identify A Concern

WARNING: This page is about a different variant/trim than selected.

Fault finding on the electrical equipment, vacuum system and air duct fault-finding has not revealed any faults. use the Vehicle Diagnostic Tester A/C system "Guided Fault Finding" function (and The Battery Regulation). Refer to appropriate System Wiring Diagrams information and MAIN WIRING DIAGRAM FOR A/C SYSTEM ACTUATORS / COOLING OUTPUT, CHECKING (CABRIOLET) (vehicle-specific repair information).

The OBD in the A/C system "Guided Fault Finding" function (for example using the Vehicle Diagnostic Tester in the A/C system "Guided Fault Finding" function) does not identify any fault status for a concern.
In the A/C system control module measured values no shut-off condition for the A/C compressor is shown. Use the Vehicle Diagnostic Tester in the A/C system "Guided Fault Finding" function.