Pressure Sensor And Switch On Refrigerant Circuit
WARNING: This page is about a different variant/trim than selected.
NOTE:
There Are Different Versions Of The Pressure Sensor And Switch With Different Functions And With Different Names. Refer to the appropriate information (REFRIGERANT CIRCUIT / REFRIGERANT CIRCUIT / REFRIGERANT CIRCUIT ) (vehicle-specific repair information).
Switching pressures, removing and installing switches as well as switch arrangement and version. Refer to the appropriate information (REFRIGERANT CIRCUIT / REFRIGERANT CIRCUIT / REFRIGERANT CIRCUIT ) (vehicle-specific repair information).
- The high pressure sensor shown is installed for example on a Golf 7 and Audi A3. Refer to the appropriate information (REFRIGERANT CIRCUIT
/ REFRIGERANT CIRCUIT
/ REFRIGERANT CIRCUIT
)
(vehicle-specific repair information).
- When voltage is applied, a version of the pressure sensor generates a square-wave signal, this signal changes along with the pressure in the system. The other version of the pressure sensor when voltage is applied it exchanges information with the control module via the data Bus (for example via the "LIN Bus") with the cosponsoring control module. Refer to appropriate System Wiring Diagrams information and use the Vehicle Diagnostic Tester in the A/C system "Guided Fault Finding" function. For this reason pay attention to the correct version of the pressure sensor.
- There are different versions of the pressure sensor, their exterior currently only differs in part number, for this reason pay attention to the allocation when replacing. Refer to the Parts Information for the correct part number. Reason: These sensors produce different signals that can only be evaluated by the respective control modules. Use the Vehicle Diagnostic Tester "Guided Fault Finding" function for the A/C system. Refer to the appropriate information (REFRIGERANT CIRCUIT / REFRIGERANT CIRCUIT / REFRIGERANT CIRCUIT ) (vehicle-specific repair information).
- One version of the pressure sensor only transmits the measured value for the refrigerant circuit pressure to the connected control module. The other version transmits the measured value for the refrigerant circuit pressure and the measured temperature to the connected control module, for this reason pay attention to the version. Refer to the Parts Information.
- The downstream control modules use this signal to calculate the refrigerant circuit pressure and activate the radiator fan and the motor, the A/C Clutch -N25- correspondingly or to change the activation of the A/C Compressor Regulator Valve -N280- using the Vehicle Diagnostic Tester in the A/C system "Guided Fault Finding" function. Refer to A/C COMPRESSOR REGULATOR VALVE -N280-, CHECKING ACTIVATION / A/C COMPRESSOR REGULATOR VALVE -N280-, REMOVING AND INSTALLING or the appropriate information (REFRIGERANT CIRCUIT / REFRIGERANT CIRCUIT / REFRIGERANT CIRCUIT ) (vehicle-specific repair information).