A/C Compressor Regulator Valve -N280-
WARNING: This page is about a different variant/trim than selected.
NOTE:
Switching pressures, removing and installing switches as well as switch arrangement and version. Refer to the appropriate information (REFRIGERANT CIRCUIT / REFRIGERANT CIRCUIT / REFRIGERANT CIRCUIT ) (vehicle-specific repair information).
- The regulator valve is installed in the A/C compressor. It is activated for example by the A/C Control Module -J301-, the Front A/C Display Control Head -E87- or the Climatronic Control Module -J255- (depending on the vehicle, possibly via the data Bus and an additional control module). Use the Vehicle Diagnostic Tester in the A/C system "Guided Fault Finding"
function. Refer to the DISPLAY AND CONTROL HEAD -J255-, REMOVING AND INSTALLING
or the appropriate information (REFRIGERANT CIRCUIT
/ REFRIGERANT CIRCUIT
/ REFRIGERANT CIRCUIT
)
(vehicle-specific repair information).
- Pressure on the low pressure side is influenced via the regulator valve and thus regulates the temperature in the evaporator.
NOTE:
The A/C Compressor Regulator Valve -N280- is a component of the A/C compressor and cannot be replaced separately on all A/C compressors. Refer to the Parts Information and A/C COMPRESSOR REGULATOR VALVE -N280-, REMOVING AND INSTALLING AND REPLACING .