DSG Transmission MECHATRONIC -J743-: Installing
Install in reverse order of removal. Note the following:
CAUTION:
There is a risk of destroying the transmission control module (Mechatronic) with static discharge.
- Always "discharge" the static electricity. Do this by touching a grounded object, for example, vehicle ground, the vehicle or the hoist.
- Do not touch the contacts in transmission connector with hands.
-- Make sure the connector is correctly connected to the Mechatronic.
-- Complete the steps required after connecting the battery. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Install the ATF suction filter. Refer to Removal and Installation .
-- Install the ATF pan. Refer to AUTOMATIC TRANSMISSION FLUID OIL PAN .
-- Fill with ATF. Refer to ATF, CHECKING LEVEL AND CORRECTING .
- After replacing the DSG Transmission Mechatronic -J743-, the corresponding "Guided Functions" must be performed with the vehicle diagnostic tester, refer to TRANSMISSION GUIDED FUNCTIONS .