Wheel Bearing Unit: Installing

Install in reverse order of removal. Note The Following: 

Tightening specifications, refer to WHEEL BEARING HOUSING AND WHEEL BEARING UNIT OVERVIEW .

-- Install the drive axle. Refer to DRIVE AXLE .

-- Tighten wheel. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- On Vehicles With Automatic Headlamp Range Control System, Perform A Basic Setting On The Headlamps. Refer to HEADLAMP RANGE CONTROL ADJUSTER -E102-, REMOVING AND INSTALLING .

-- If the vehicle level sensor was removed and installed on a vehicle with electronically controlled damping or if the linkage was loosened, the control position must be reprogrammed. Refer to CONTROL POSITION, PROGRAMMING USING VEHICLE DIAGNOSTIC TESTER .

-- If the control position was reprogrammed on vehicles with lane assist, the directional stabilization assistance control module -J759- must be recalibrated. Refer to LANE ASSIST CALIBRATION PROCEDURE .