Level Control System Sensor: Installing

Install In Reverse Order Of Removal. Note The Following: 

Tightening specifications, refer to TRACK CONTROL ARM, BALL JOINT, GUIDE LINK AND LEVEL CONTROL SYSTEM SENSOR OVERVIEW .

Guide the retaining hook on the sensor bracket into the subframe.

The sensor lever must point toward the back.

After Loosening, Check Basic Setting Of Headlamp Adjustment. Refer to HEADLAMP, ADJUSTING .

-- If the vehicle level sensor was removed and installed on a vehicle with electronically controlled damping or if the linkage was loosened, the control position must be reprogrammed. Refer to CONTROL POSITION, PROGRAMMING USING VEHICLE DIAGNOSTIC TESTER .

-- If the control position was reprogrammed on vehicles with lane assist, the directional stabilization assistance control module -J759- must be recalibrated. Refer to LANE ASSIST CALIBRATION PROCEDURE .