Ribbed Belt, Removing And Installing, Vehicles With Electro-Mechanical Power Steering: Removing

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Idler Roller Bolt -Arrow-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the supercharger ribbed belt. Refer to SUPERCHARGER RIBBED BELT, REMOVING AND INSTALLING .

-- Remove the bolt -arrow- using the Wrench - Door Adjusting - Box Wrench 3320/2.

-- Push the idler roller to the fan shroud.

-- Remove the bolt -2- on the left front coolant pipe.

Fig 2: Coolant Pipes

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The installed position is shown in the illustration with the engine removed.

Ignore item -1-.

-- Remove the front noise insulation -1-. Refer to Front Noise Insulation Removing And Installing .

Fig 3: Noise Insulation Panels

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1- for the left front coolant pipes.

Fig 4: Locating Lower Coolant Pipe Bolt

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The installed position is shown in the illustration with the engine removed.

Ignore the -arrows-.

CAUTION:

Risk of damage due to reversed running direction on a used ribbed belt.

For installing the ribbed belt again, mark the running direction with chalk or a felt tip pen.

-- To release the tension on the ribbed belt, pivot the tensioner clockwise in direction of -arrow- and then lock using a Locking Pin T10060A.

Fig 5: Releasing Tension On Ribbed Drive Belt

Courtesy of AUDI OF AMERICA, LLC

-- Remove the ribbed belt.