-- Brake Rotor, Removing
To avoid a false measurement, place the brake rotor on a surface that will not conduct electricity (for example, a wooden table).
The surface must be clean and dry
The brake rotor must be clean and dry
-- Place the :VAS6813 again flush on the outer edge of the brake rotor.
The measurement must take place again on all three measurement locations to guarantee a correct check.
-- Move the :VAS6813 -1- back along the outer edge -2- until the laser beam points exactly on the mark -D- on the brake rotor.
-- Determine the wear on all three measurement locations of the brake rotor from "1 to 3".
-- Read the displayed value on the :VAS6813
If one of the three wear values -C- is reached or falls short the brake rotor must be replaced.
If there is abrasion both brake rotors on both sides of the axle must always be replaced.