Center Differential Ball Bearing, Removing And Installing

WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Press Plate VW401
Press Plate VW402
Press Piece - Multiple Use VW412
Press Piece - Bushing - 50mm Diameter VW432
Bearing Installer - Carrier Bearing 3350
Puller - Kukko Quick Action Separating Tool - 22-115mm 17/2

Procedure

Fig 1: Identifying Center Differential

Courtesy of AUDI OF AMERICA, LLC

-- Remove the center differential housing, refer to CENTER DIFFERENTIAL, REMOVING AND INSTALLING .

-- Remove the center differential -1- from the input shaft.

Fig 2: Ball Bearing Removed From Center Differential

Courtesy of AUDI OF AMERICA, LLC

A - Puller - Kukko Quick Action Separating Tool - 22-115mm 17/2

The Press Piece - Bushing - 50mm Diameter VW432 faces the ball bearing.

Fig 3: Ball Bearing Installed Onto Center Differential

Courtesy of AUDI OF AMERICA, LLC