Separating cover from upholstery

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Cover, Plastic Clips & Fastening Strips

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Cover

Removal:

Pry out grip channels - 3 - from plastic clips - 2 - using a screwdriver.
Remove cover - 1 -.
For vehicles with LATCH "Lower Anchor and Tethers for Children" bracket and new cover - 1 -, cover must be cut in at LATCH "Lower Anchor and Tethers for Children" bracket.

Installing:

Installation is reverse of removal. Observe the following when doing so:

Replaced damaged plastic clips.
Press in first the plastic clips of transverse beam.

2 - Plastic clips

Replace if damaged

3 - Fastening strips