Brake Booster: Installing

-- Insert the brake booster in the vehicle.

Make sure the seal is seated correctly.

-- Install the bolts from the brake booster -1- to the mounting bracket and tighten them.

Fig 1: Brake Booster Bolts, Brake Lines & Brake Master Cylinder Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Press the vacuum line -3- into the brake booster.

Fig 2: Identifying Brake Master Cylinder Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake master cylinder -15-, refer to MASTER BRAKE CYLINDER .

Fig 3: Identifying Brake Master Cylinder Components

Courtesy of AUDI OF AMERICA, LLC

-- Install the brake fluid reservoir -1-, refer to BRAKE FLUID RESERVOIR .

-- With manual transmissions, insert the clutch hydraulic line -5- into the brake fluid reservoir.

-- Fill the brake fluid up to the marking.

-- Bleed the brake system.

-- With manual transmissions, bleed the clutch, refer to CLUTCH MECHANISM, BLEEDING for 0B2, or CLUTCH MECHANISM, BLEEDING for 0B4 .

-- Install the plenum chamber bulkhead, refer to OVERVIEW - BULKHEAD .

-- Install the tower brace, refer to TOWER BRACE, REMOVING AND INSTALLING .

-- Install the engine cover.

Brake Pedal and Brake Booster, Connecting

-- Hold the push rod ball head in front of the mount and push the brake pedal toward the brake booster, so that the ball head clicks into place.

-- Install the brake lamp sensor, refer to BRAKE LAMP SENSOR .

-- Install the footwell vents -A-B-.

Fig 4: Identifying Footwell Vents

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the footwell vent screw -A-.

-- Connect the connector -C-.

-- Install the driver side storage compartment -1 to 3-.

Fig 5: Identifying Driver Side Storage Compartment

Courtesy of AUDI OF AMERICA, LLC