Brake Booster Pressure Sensor, Removing And Installing: Removing

-- Remove the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

NOTE:

The Brake Booster Pressure Sensor -G294- is located in the plenum chamber near the brake booster.

-- Disconnect the connector -1-.

-- Remove the pressure sensor in the direction of the -arrow-.

Fig 1: Identifying Pressure Sensor

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The pressure sensor is secured with clips.

-- Release the clips with pliers -1-.

Fig 2: Identifying Brake Booster Pressure Sensor G294, Clips And Pliers

Courtesy of AUDI OF AMERICA, LLC

-- Carefully pry off the Brake Booster Pressure Sensor -G294-.