LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> S4 Automatic DCT >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Wheels & Tire General Information (Sedan) >> 44 Wheels, Tires, Wheel Alignment >> Wheels/Tires/Tire Pressure Monitoring Assembly >> Wheel Electronics, TPMS, BERU System

Wheel Electronics, TPMS, BERU System

Special Tools And Workshop Equipment Required 

Siemens wheel electronics system, refer to WHEEL ELECTRONICS, TPMS, SIEMENS SYSTEM .

Fig 1: Identifying Tire Pressure Monitor
GWWA44-10029Courtesy of AUDI OF AMERICA, LLC
WARNING:

If tire sealant was used, then the wheel electronics on that particular wheel must be replaced.

WARNING:

Damaged wheel electronics must be replaced.

-- Push the wheel electronics -1- into the bed.

Fig 2: Pressing Wheel Electronics Into Bed
GWWA44-0086Courtesy of AUDI OF AMERICA, LLC

-- Install on the valve from the back with a microencapsulated screw  Microencapsulated Screw -6-.

NOTE:

Replace the microencapsulated screw.

Tighten the microencapsulated screw to 4 Nm on all models.

Tightening specification for all models: 4 Nm