Center Differential, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the center differential housing O-ring.

If the center differential -1- was removed:

-- Position the center differential on the input shaft splines. Rotate the center differential slightly when doing this.

-- Make sure the center differential can be turned by hand.

-- Place the housing with the input shaft installed on the center differential. Rotate the housing slightly if necessary.

-- Tighten the center differential housing bolts, -- Tighten bolts to 8 Nm in -1 to 6- sequence. --.

Fig 1: Center Differential Housing - Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Clean and install the tunnel crossmember, refer to TUNNEL CROSSMEMBER, REMOVING AND INSTALLING .

-- Install the driveshaft, refer to DRIVESHAFT, REMOVING AND INSTALLING .

-- Install and align the exhaust system free of tension, refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .

-- Fill gear oil in transfer case, refer to GEAR OIL, DRAINING AND FILLING, TRANSFER CASE .