LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> S4 Automatic DCT >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.0L - Crankshaft & Cylinder Block - Engine Code(S): CCBA, CGXC & CTUB (Sedan) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Transmission Side >> Overview - Drive Plate

Overview - Drive Plate

NOTE:

For assembly work, secure the engine on the Engine and Gearbox Bracket VAS6095A. Refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .

Fig 1: Overview Of Drive Plate Assembly
GWWA13-10557Courtesy of AUDI OF AMERICA, LLC
  1. Drive Plate
    • With the bearing flange
    • Check the running surfaces on the bearing flange and the clutch module holes for cracks and wear grooves.
    • Removing and installing. Refer to DRIVE PLATE, REMOVING AND INSTALLING .
  2. Bolt
    • 60 Nm + 90° turn
    • Replace
  3. Needle Bearing
  4. Sensor Wheel
    • For Engine Speed Sensor -G28-
  5. Crankshaft
  6. Alignment Pin
  7. Crankshaft Shaft Seal, Transmission Side
scientia non olet · About LEMON Manuals