LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> S4 Automatic DCT >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.0L - Crankshaft & Cylinder Block - Engine Code(S): CCBA, CGXC & CTUB (Sedan) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Transmission Side >> Drive Plate, Removing And Installing >> Installing

Drive Plate, Removing And Installing: Installing

Install in reverse order of removal. Note the following:

NOTE:

Replace the bolts that were tightened with an additional turn.

There is a needled bearing in the drive plate. Check if the needle bearing is inserted before installing. Remove needle bearing from drive plate and install. Refer to NEEDLE BEARING IN DRIVE PLATE, REPLACING .

-- Be careful of the alignment bushings during installation.

-- Turn the Counterhold - Flywheel 10-201 to tighten the bolts.

scientia non olet · About LEMON Manuals