All Wheel Drive Control Module -J492-, ADDITIONAL WORK AFTER REPLACING

NOTE:

Only perform the additional work only if the All Wheel Drive Control Module -J492- was replaced.

-- Connect the Vehicle Diagnostic Tester and turn on the ignition.

-- Select the function 22 - All Wheel Drive Electronics in the Vehicle Diagnostic Tester under Guided Functions in the directory 22- Replacing Control Module .

Follow all the instructions given by the Vehicle Diagnostic Tester exactly.

With the Vehicle Diagnostic Tester the installed rear final drive is "adapted" on the All Wheel Drive Control Module -J492-.

NOTE:

A system check will take place when the 22 - Control Module, Replacing function is complete. If malfunctions appear, then use "Guided Fault Finding" to correct them.