Input Shaft Seal, Replacing, 0BD: Notes

• The flange/driveshaft used before must be installed.
• If the flange/driveshaft is also being replaced, do the following. Refer to FLANGE SHAFT RING, REPLACING, 0BD .

Special tools and workshop equipment required 

• Puller - Multiple Use VW391
• Slide Hammer Set VW771
• Slide Hammer Set - Hook VW771/37
• Seal Installer - Driveshaft Flange T40112
• Retainer - Drive Flange 3028
• Seal Installer - Wheel Bearing Seal 3143
• Holding Fixture - Gearbox Adapter T10235
• Friction Gauge VAS6222
• Inductive Heater VAS6414
• Sealing Grease G 052 128 A1
• Locking Fluid AMV 185 101 A1
• Three M8 x 25 bolts
• Two M10 x 40 bolts