Gear Oil, Checking Level, 0BC

Special tools and workshop equipment required 

• Drip Tray

-- Remove the plug to check the transmission fluid level -arrow-.

Fig 1: Locating Rear Final Drive Plug For Checking Fluid Level (0BC)

Courtesy of AUDI OF AMERICA, LLC

The oil level is correct when the rear final drive is filled up to the lower edge of the oil fill hole.

• Use correct transmission fluid specification. Refer to appropriate FLUID CAPACITY TABLE information in MAINTENANCE article.

-- Install the plug -arrow- and tighten it.

Tightening specification 30 Nm.