ATF Level, Checking, 0BE, 0BF

Test Requirement

• ATF temperature: 10 °C to 60 °C (50° to 140 °F)
• The rear final drive must be in the installed position.
• The vehicle must be level.

Special tools and workshop equipment required 

• Drip Tray

-- Remove the ATF check plug -1- to check the ATF level.

Fig 1: Locating ATF Plugs

Courtesy of AUDI OF AMERICA, LLC

• The ATF level is correct when the rear final drive is filled to the lower edge of the fill hole.

If the ATF is correct:

-- Install the new ATF check plug and fasten. Tightening Specification, refer to -item  13- ATF Check Plug (See Figure).

If the ATF is not correct:

-- Fill the ATF. Refer to ATF, FILLING, 0BE, 0BF .