Flange Shaft Seals, Replacing, Rear Final Drive Removed: Installing: Notes
Install in reverse order of removal. Pay attention to the following:
Install Right Shaft Seal
-- Coat the outer circumference and the sealing lips on the shaft seal with ATF.
-- Install the shaft seal all the way. Be careful not to bend it.
Installing Left Shaft Seal
-- Coat the outer circumference and the sealing lips on the shaft seal with ATF.
-- Install the shaft seal all the way. Be careful not to bend it.
-- Install the flange shaft.
If it is not possible to install the flange shaft all the way in by hand, then use a plastic mallet.
-- Tighten the new flange shaft bolt to the tightening specification. Refer to -item 1- Bolt (See Figure).
-- Install the rear final drive. Refer to REAR FINAL DRIVE, REMOVING AND INSTALLING, AUDI A4, A5 COUP E /SPORTBACK/CABRIOLET, A6, A7 .
-- Check the ATF level in the rear final drive. Refer to ATF LEVEL IN REAR FINAL DRIVE 0BF AND 0BE, CHECKING .