Transmission Fluid Temperature Sensor 2 -G754-, REMOVING AND INSTALLING: Removing

Procedure

Fig 1: Identifying Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

Transmission Installed:

-- Remove the rear noise insulation -2-. Refer to NOISE INSULATION, REMOVING AND INSTALLING .

CAUTION:

Danger of Causing Damage to the Transmission.

Without any or with too little manual transmission fluid inside the transmission:

do not start the engine and
do not tow the vehicle

Transmission Removed:

The transmission is secured to the engine/transmission holder. Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .-

Transmission, Removed or Installed:

-- Place the Used Oil Collection and Extraction Unit SMN372500 under the transmission.

-- Disconnect the connector -2- from Transmission Fluid Temperature Sensor 2 -G754-.

Fig 2: Identifying Transmission Fluid Temperature Sensor

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Protect the connector -2- and the contacts on Transmission Fluid Temperature Sensor 2 -G754- from transmission fluid. Clean the connectors immediately if they come in contact with transmission fluid (Manual Transmission Fluid). Transmission fluid can cause contact problems in the connector contacts.

-- Remove the Transmission Fluid Temperature Sensor 2 -G754- -1-.

-- Drain the transmission fluid (MTF).

Install in reverse order of removal. Note the following: