Display And Control Head, Removing And Installing: Installing

Installation is carried out in the reverse order while observing the following.

When replacing a Climatronic Control Module -J255- A/C display and control head, pay attention to the exact allocation. Refer to DISPLAY AND CONTROL HEAD LOCATION .

Mount the trim on the display and control head on the Audi Q5.

-- Clean the adhesive surface -D- on the display and control head -A-, for example, with cleaning solution D 009 401 04 .

Fig 1: Audi Q5 Climatronic Control Module Additional Trim Piece

Courtesy of AUDI OF AMERICA, LLC

-- Install the display and control head -A-.

NOTE:

The trim piece -B- is supplied with a two-sided adhesive strip already installed -C-

If the trim -B- is going to be re-used when replacing the display and control unit, the Climatronic Control Module -J255- -A- is also reused. Remove the adhesive strip -C- from the trim -B-. Clean the adhesive surface on the trim -B- as described in the instructions which came with the adhesive strip. Affix to the trim piece -B- a strip (dimension: 204 mm x 10 mm) of the two-sided adhesive tape -C- with material strength approximately 1.2 mm (for example with adhesive tape D 438 515 A1 ).

-- Mount the trim piece -B- with the adhesive tape -C- onto the adhesive surface -D- of the display and control head -A- and then align it -B-.

-- Press the trim piece -B- onto the surface -D-.

After replacing/installing the Climatronic Control Module -J255- A/C display and control head, always perform the follow work (refer to using the Vehicle Diagnostic Tester in the "Guided Fault Finding " function):

-- Re-code (or check the coding) of the Climatronic Control Module -J255- A/C display and control head.

-- Perform the basic setting for the Climatronic Control Module -J255- A/C display and control head.

-- Check the DTC memory of the Climatronic Control Module -J255- A/C display and control head (correct the cause for any malfunctions displayed) and erase.

-- Check the adaptation of the Climatronic Control Module -J255- A/C display and control head and correct if necessary.

-- Perform the output diagnostic test mode for the Climatronic Control Module -J255- A/C display and control head (depending on the type of complaint).