LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> Q5 3.2 >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> Heating, Ventilation & Air Conditioning (1 Of 2) (As Of 06.2014) >> 87 Air Conditioning >> Refrigerant Circuit >> Condenser, Removing And Installing >> Condenser, Removing And Installing >> Installing

Condenser, Removing And Installing: Installing

Installation is done is reverse order, observe the following:

NOTE:

The removed condenser contains refrigerant oil that must be returned to the refrigerant circuit (with the new condenser). Refer to REFRIGERANT CIRCUIT COMPONENTS, REPLACING (Refrigerant R134a, Servicing; Refrigerant Circuit Components, Replacing).

-- Install the refrigerant lines on the condenser. Refer to REFRIGERANT LINES, DISCONNECTING AND CONNECTING AT CONDENSER .

-- Evacuate the refrigerant circuit and fill it. Refer to USING SERVICE STATION (Refrigerant R134a, Servicing; Refrigerant Circuit, Using Service Station).

-- Operate the A/C system after filling the refrigerant circuit. Refer to A/C SYSTEM, STARTING OPERATION AFTER FILLING REFRIGERANT CIRCUIT .

-- Install the remaining removed components.

-- Turn on the ignition.

-- Check the DTC memory and erase any displayed entries using the Vehicle Diagnostic Tester in the "Guided Fault Finding  " function.

scientia non olet · About LEMON Manuals