LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> Q5 3.2 >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> A/C Compressor >> Heating, Ventilation & Air Conditioning (1 Of 2) (As Of 06.2014) >> 87 Air Conditioning >> Refrigerant Circuit >> Condenser, Removing And Installing >> Condenser, Removing And Installing >> Removing

Condenser, Removing And Installing: Removing

Fig 1: Identifying Air Duct Components
GWWA24-10507Courtesy of AUDI OF AMERICA, LLC

-- Turn off the ignition.

-- Discharge the refrigerant circuit. Refer to USING SERVICE STATION (Refrigerant R134a, Servicing; Refrigerant Circuit, Using Service Station).

-- Remove the refrigerant lines from the condenser. Refer to REFRIGERANT LINES, DISCONNECTING AND CONNECTING AT CONDENSER .

-- Remove the bolts -arrows-.

-- Remove the left and right air guide -1- from the intermediate flange -2- on the air filter housing.

-- Unlock the retaining straps -arrows A- (each two straps, one on top and one below on the air guide) and move the left and right air guide -1- toward the center of the vehicle -arrow B-.

Fig 2: Locating Left & Right Air Duct Tabs
GWWA19-10441Courtesy of AUDI OF AMERICA, LLC
NOTE:

On vehicles with a grille -A- (only specific vehicles with safety feature against rocks and stone chips) the front bumper cover and grille -A- must be removed in order to move and remove the air duct -B-.

Fig 3: View Of Grille And Air Ducts
GWWA87-11526Courtesy of AUDI OF AMERICA, LLC

-- Unlock the retaining clamps -1- in -arrow direction A- and remove the condenser -2- upward and out of the brackets on the radiator -arrows B-.

Fig 4: Condenser
GWWA87-10374Courtesy of AUDI OF AMERICA, LLC