LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> Q5 3.2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 559 (Final Drive & Differential - MULTITRONIC Transmission 0AW (Sedan) (As Of 11.2014)) >> 39 Final Drive, Differential >> Final Drive >> Overview - Final Drive

Overview - Final Drive

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2016 Audi A4, 2015 Audi A4, 2014 Audi A4, 2013 Audi A4, and 2012 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Refer to GENERAL REPAIR INFORMATION .

Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

Fig 1: Front Final Drive Sealing Rings Overview
GWWA39-10286Courtesy of AUDI OF AMERICA, LLC
  1. Shaft Seal
  2. Differential
  3. Bolt
  4. Shaft Seal
  5. Right Flange Shaft
  6. Circlip
  7. Fill and Check Plug
    • 30 Nm
    • Replacing
    • For the transmission fluid inside the front final drive
  8. Front Final Drive Cover
  9. O-Ring
    • On the front final drive cover
    • Replacing
  10. Bolt
    • 10 Nm
  11. Gearshift Lever
  12. Shaft Seal
  13. Transmission
  14. Left Flange Shaft
  15. Bolt
    • Tightening specification, 10 Nm + 90° turn
    • Replacing
  16. Bracket
    • Removing and installing is only possible for removed transmissions. Refer to OVERVIEW - FINAL DRIVE -item 16- Bracket. .
  17. Ball Bearing
    • For the left flange shaft
    • Removing and installing is only possible for removed transmissions. Refer to OVERVIEW - FINAL DRIVE -item 17- Ball Bearing. .
  18. Circlip
  19. Shaft Seal
  20. Dual Mass Flywheel
scientia non olet · About LEMON Manuals