LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> Q5 3.2 >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> EXTERIOR LIGHTS, SWITCHES (2 of 2) (CABRIOLET) >> 94 Exterior Lights, Switches >> Steering Column Switch Module >> Steering Column Switch Module, Removing And Installing >> Removing

Steering Column Switch Module, Removing And Installing: Removing

-- Turn off the ignition and remove the key.

-- Adjust steering wheel downward and to rear as far as possible, use entire adjustment range of steering column adjustment for this.

-- Remove the driver airbag, refer to OVERVIEW - DRIVER SIDE AIRBAG .

-- Remove the steering wheel, refer to AIRBAG STEERING WHEEL, REMOVING AND INSTALLING .

-- Remove the steering column trim panel, refer to UPPER STEERING COLUMN TRIM PANEL, REMOVING AND INSTALLING .

-- Remove the bolt -1-.

Fig 1: Identifying Connectors -2- & -3-
GWWA94-10523Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -2-.

WARNING:

The technician must discharge static electricity before disconnecting the connector -3-, for example by touching the door striker pin.

-- Disconnect the connector -3-.

-- Press the catch -1- in direction of -arrow- until the connector -2- disengages.

Fig 2: Disengage Connector Lock To Release Connector
GWWA69-0461Courtesy of AUDI OF AMERICA, LLC

-- Remove the steering column switch module carefully.