Fog Lamp, Adjusting: Notes
Checking And Adjusting Conditions
- Tire pressure is OK.
- The headlamp lens must be clean and dry.
- The headlamp lens may not be damaged.
- Headlamp-reflector and lamp are OK.
- Roll the vehicle several yards or move it back and forth several times to seat the springs.
- The parking brake must not be engaged so that the vehicle is not under stress.
- The vehicle and headlamp adjusting unit must be on a level surface.
- The headlamp adjusting unit must be aligned to the vehicle, refer to the Headlamp Adjusting Unit Instructions.
- The inclination dimension is set on the headlamp adjusting unit, refer to the Headlamp Adjusting Unit Operating Instructions.
- Vehicle load must be created.
Vehicle load on driver's seat in otherwise unloaded vehicle (curb weight).
- One person or 75 kg.
CAUTION:
Risk of unintentional engine start and poisonous gas in closed spaces when working on vehicles with ignition turned on or on vehicles that are ready to drive. Risk of limbs and/or clothing being pinched and pulled.
Perform the following items before turning on the ignition:
- Put the selector lever into position P.
- Activate the parking brake.
- Turn off the ignition.
- Open the hood.
- Connect the charging unit for example, Battery Charger VAS 5095A to the battery jump start terminal for the 12V vehicle electrical system.
- Turn on the ignition