LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> Q5 2.0T >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Heating, Ventilation & Air Conditioning (2 Of 2) (As Of 06.2014) >> 87 Air Conditioning >> Front Heater And A/C Unit >> Overview - Air Distribution Housing Doors And Partitions >> OVERVIEW - AIR DISTRIBUTION HOUSING DOORS AND PARTITIONS, "Convenience" VERSION

OVERVIEW - AIR DISTRIBUTION HOUSING DOORS AND PARTITIONS, "Convenience" VERSION

NOTE:

The air distribution housing is not disassembled .

There are different versions of the air distribution housing depending on which A/C system is installed in the vehicle, "Convenience" or "Basis" .

Depending on the production date, there are different versions of the levers and connecting elements on the A/C unit. At the start of production, the levers -A- were installed with a closed pin and the connecting rod -B-. In MY 2008, the levers -C- have a slotted pin and connecting rod -D-. When replacing, be sure to use the correct version..

Fig 1: Air Conditioner, Levers And Connecting Elements
GWWA87-10599Courtesy of AUDI OF AMERICA, LLC
Fig 2: Identifying Air Distribution Housing Comfort A/C System
GWWA87-10571Courtesy of AUDI OF AMERICA, LLC
  1. "Convenience" Air Distribution Housing
  2. Left Housing Half
  3. Right Housing Half
  4. Upper Housing for Vents
  5. Lever
  6. Lever
  7. Door for Left Indirect Ventilation Vent
  8. Door in the "Defrost" Vent
  9. Door for Right Indirect Ventilation Vent
  10. Lever
  11. Lever
  12. Vent Door Leading to the Left Instrument Panel Vent
  13. Vent Door Leading to the Front Left Footwell Vent
  14. Lever
  15. Lever
  16. Vent Door Leading to the Rear Left Footwell Vent
  17. Lever
  18. Vent Door Leading to the Right Instrument Panel Vent
  19. Vent Door Leading to the Front Right Footwell Vent
  20. Lever
  21. Lever
  22. Vent Door Leading to the Rear Right Footwell Vent
  23. Shaft
  24. Shaft
  25. Connecting Rod
  26. Connecting Rod
  27. Connecting Rod
  28. Connecting rod
  29. Separator Wall
    • If the air flow to the front and rear vents is separated from each other; the requirement for different front and rear air temperatures (depends on the setting of each temperature door).
  30. Grommet
    • Glued in the separating wall, refer to -item  29- "Separator Wall".
  31. Grommet
    • Glued in the separating wall, refer to -item  29- "Separator Wall".
  32. Door in the Vent Leading to the Left Center Instrument Panel Vents
  33. Door in the Vent Leading to the Right Center Instrument Panel Vents
  34. Separator Wall
    • If the air flow to the left and right vents is separated from each other; the requirement for different front and rear air temperatures (depends on the setting of each temperature door).
  35. Vent Door Leading to the Rear Right Center Console Vent
  36. Vent Door Leading to the Rear Right Center Console Vent
scientia non olet · About LEMON Manuals