Overview - Final Drive
WARNING: This page is about a different car, the 2014 Audi A5, 2013 Audi A5, 2012 Audi A5, and 2011 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Refer to GENERAL REPAIR INFORMATION .
Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
- Shaft Seal
- For the left flange shaft
- Replacing. Refer to LEFT SEAL, REPLACING .
- Differential
- Bolt
- Tightening specification and sequence. Refer to FINAL DRIVE .
- Shaft Seal
- For the right flange shaft
- Replacing. Refer to RIGHT SEAL, REPLACING .
- Right Flange Shaft
- Removing and installing. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .
- Circlip
- Replacing. Refer to RIGHT FLANGE SHAFT, REMOVING AND INSTALLING .
- Fill and Check Plug
- 30 Nm
- Always replace
- For the transmission fluid inside the front final drive
- Front Final Drive Cover
- Pay attention to the alignment sleeves
- Removing and installing is only possible for removed transmissions. Refer to LEFT SEAL, REPLACING .
- After removing the front final drive cover, pre-fill. Refer to GEAR OIL, DRAINING AND FILLING .
- O-Ring
- Always replace
- On the front final drive cover
- Bolt
- Tightening specification. Refer to FINAL DRIVE .
- Gearshift Lever
- Shaft Seal
- For the selector shaft
- Replacing. Refer to SELECTOR SHAFT SEAL, REPLACING .
- Transmission
- Left Flange Shaft
- Removing and installing. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .
- Bolt
- Tightening specification. Refer to FINAL DRIVE .
- Bracket
- Removing and installing is only possible for removed transmissions. Refer to FINAL DRIVE .
- Ball Bearing
- For the left flange shaft
- Removing and installing is only possible for removed transmissions. .
- Circlip
- Always replace
- Removing and installing is only possible for removed transmissions. Refer to FINAL DRIVE or FINAL DRIVE .
- Shaft Seal
- For the input shaft
- Replacing. Refer to INPUT SHAFT SEAL, REPLACING .
- Dual Mass Flywheel
- Removing and installing is only possible for removed transmissions. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .