LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> Q5 2.0T >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L - Cylinder Head & VALVETRAIN - Engine Code(S): CAEB, CHJA, CPMA & CPMB >> 15 Cylinder Head, VALVETRAIN >> Timing Chain Cover >> Vibration Damper Sealing Ring, Replacing >> Installing

Vibration Damper Sealing Ring, Replacing: Installing

Fig 1: Identifying Crankshaft Seal Installer T10354
GWWA13-11008Courtesy of AUDI OF AMERICA, LLC

-- Clean the running and sealing surface.

-- Push the seal -arrow- on the Seal Installer - Crankshaft T10354.

-- Push the seal -arrow- with the Seal Installer - Crankshaft T10354 on the Tensioning Pins T10531/2 and place on the lower timing chain cover.

Fig 2: Identifying Crankshaft Seal Installer T10354 And Tensioning Pins T10531/2
GWWA13-11059Courtesy of AUDI OF AMERICA, LLC

-- Additional attach the Press Piece - Gearbox T10375 and tighten the Knurled Nut T10531/4.

Fig 3: Driving Seal In Using Seal Installer - Crankshaft T10354
GWWA13-11060Courtesy of AUDI OF AMERICA, LLC

-- Drive the seal in all the way using the Seal Installer - Crankshaft T10354. T10354

NOTE:

Replace the vibration damper bolt.

Replace the O-ring.

Further installation is done in the reverse order of removal. Note the following:

-- Install the vibration damper, refer to VIBRATION DAMPER, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals