LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> Q5 2.0T >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 2.0L - Turbocharger & Supercharger - Engine Code(S): CAEB, CHJA, CPMA & CPMB >> 21 Turbocharger, Supercharger >> Charge Air System >> Charge Air Cooler, Removing And Installing >> Charge Air Cooler, Removing And Installing, Non-Hybrid Vehicles >> Removing

Charge Air Cooler, Removing And Installing, Non-Hybrid Vehicles: Removing

NOTE:

Follow all the rules of cleanliness, refer to CLEAN WORKING CONDITIONS .

-- Remove the front bumper cover, refer to BUMPER COVER, REMOVING AND INSTALLING .

-- Remove the bolts -arrows-.

Fig 1: Identifying Air Duct Components
GWWA24-10507Courtesy of AUDI OF AMERICA, LLC

-- Remove the air guide -1- and intermediate flange -2- from the air filter housing.

-- Open the retainers -arrows A- and move air guide -1- to the right to toward the center of the vehicle -arrow B-.

Fig 2: Locating Left & Right Air Duct Tabs
GWWA19-10441Courtesy of AUDI OF AMERICA, LLC

-- Remove the air guide hose from the charge air cooler by loosening the hose clamp -arrow-.

Fig 3: Identifying Air Guide Hose Components
GWWA21-10232Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -1-.

-- Remove the air guide hose from the charge air cooler by loosening the hose clamp -1-.

Fig 4: Identifying Air Guide Hose
GWWA21-10233Courtesy of AUDI OF AMERICA, LLC

-- Push the lock downward -arrow A- and move the charge air cooler upward slightly in direction of -arrow B-.

-- Remove the charge air cooler upward from the radiator. Pay attention to the left air guide at the same time.