Steering Column Switch Module, Removing And Installing: Removing
-- Turn off the ignition and remove the key.
-- Adjust steering wheel downward and to rear as far as possible, use entire adjustment range of steering column adjustment for this.
-- Remove the driver airbag, refer to OVERVIEW - DRIVER SIDE AIRBAG .
-- Remove the steering wheel, refer to AIRBAG STEERING WHEEL, REMOVING AND INSTALLING .
-- Remove the steering column trim panel, refer to UPPER STEERING COLUMN TRIM PANEL, REMOVING AND INSTALLING .
-- Remove the bolt -1-.
-- Disconnect the connector -2-.
The technician must discharge static electricity before disconnecting the connector -3-, for example by touching the door striker pin.
-- Disconnect the connector -3-.
-- Press the catch -1- in direction of -arrow- until the connector -2- disengages.
-- Remove the steering column switch module carefully.