AWD Control Module, Additional Work After Replacing
Special tools and workshop equipment required
- Vehicle Diagnostic Tester
NOTE:
Perform the following only if the All Wheel Drive (AWD) control module -J492- was replaced.
-- Connect the vehicle diagnostic tester and turn on the ignition.
-- Select 22 - Replace Control Module in the vehicle diagnostic tester under Guided Functions in directory 22 - AWD Electronics .
- Follow all the instructions in the VAS 5051 exactly.
Using the vehicle diagnostic tester, "adapt" the rear final drive, which was just installed, to the AWD control module.
NOTE:
A system check takes place after 22 - Replace Control Module finishes. Use "Guided Fault Finding" to correct any malfunctions that may have been detected.