AWD Control Module -J492-

NOTE:

Installed location of the All Wheel Drive Control Module -J492-. Refer to TRANSMISSION CONTROL COMPONENT LOCATION OVERVIEW .

Removing and installing is on the A4 Sedan.

-- Remove the luggage compartment floor covering.

-- Remove the covering and the vehicle tools bracket.

-- Remove the All Wheel Drive Control Module -J492- -A- from the bracket -C-.

Fig 1: All Wheel Drive (AWD) Control Module -J492- In Audi A4 Sedan, Audi A5 Coupe And Audi A5 Cabriolet

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -B- from the All Wheel Drive Control Module -J492-.

-- Install the All Wheel Drive Control Module -J492- in reverse order of removal.

If the All Wheel Drive Control Module -J492- was replaced then additional work is necessary. Refer to ADDITIONAL WORK AFTER REPLACING All Wheel Drive Control Module -J492- .