Gear Oil, Checking Level, 0BE, 0BF
Test requirement
- Gear oil temperature: 10° C to 60° C (50° F to 140° F)
- The rear final drive must be in the installed position.
- The vehicle must be horizontal.
- Gear oil plug overview, refer to GEAR OIL DRAIN AND INSPECTION PLUGS OVERVIEW, 0BE, 0BF
Special Tools And Workshop Equipment Required
- Drip Tray
Rear Final Drive 0BF
-- Remove the gear oil inspection plug -arrow-, located on the right side of the final drive.
Rear Final Drive 0BE
-- Remove the gear oil inspection plug -1-.
Continued Steps for All Rear Final Drives.
- The oil level is correct when the rear final drive is filled up to the lower edge of the filler hole.
- Transmission fluid specification, refer to CODE, TRANSMISSION ALLOCATION, RATIOS AND CAPACITIES .
-- If necessary fill the gear oil.
-- Install the gear oil inspection plug -arrow- and tighten. Tightening specification -item 22- in FINAL DRIVE 0BE, 0BF OVERVIEW