Overview - Charge Air System
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.
- Charge Air Cooler Housing
- with air guides
- Removing and installing, refer to CHARGE AIR COOLER HOUSING, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Seal
- Replacing
- Seal
- Replacing
- Charge Air Cooler
- Removing and installing, refer to CHARGE AIR COOLER, REMOVING AND INSTALLING .
- Bolt
- 3.2 Nm
- Seal
- For the charge air cooler
- Replacing
- Bolt
- Tightening specification, refer to -Item 13- in OVERVIEW - INTAKE MANIFOLD .
- Air Guide Hose
- to the air guide pipe at the turbocharger
- Bolt
- 9 Nm
- Turbocharger Recirculation Valve -N249-
- Removing and installing, refer to TURBOCHARGER RECIRCULATING VALVE -N249-, REMOVING AND INSTALLING .
- O-Ring
- Replacing
- O-Ring
- Replacing
- Charge Air Pressure Sensor -G31-
- Removing and installing, refer to CHARGE AIR PRESSURE SENSOR -G31-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Air Guide
- Seal
- Replacing
- Bolt
- 9 Nm
- Air Guide
- Seal
- Replacing
- Air guide hose
- to the air guide pipe at the turbocharger
- O-Ring
- Replacing
- Turbocharger Recirculation Valve Bank 2 -N427-
- Removing and installing, refer to TURBOCHARGER RECIRCULATION VALVE BANK 2 -N427- .
- Bolt
- 9 Nm
- O-Ring
- Replacing
- Charge Air Pressure Sensor 2 -G447-
- Removing and installing, refer to CHARGE AIR PRESSURE SENSOR 2 -G447-, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Throttle Valve Control Module -J338-
- Removing and installing, refer to THROTTLE VALVE CONTROL MODULE -J338-, REMOVING AND INSTALLING .
- Seal
- Replacing
- Adjusting Buffer
- For the charge air cooler
- Bolt
- 9 Nm
- Grommet
- Seal
- Replacing