LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2011 >> A8 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (4.0L - Turbocharger & Supercharger - Engine Code(S): CEUA, CGTA, CTFA & CTGA) >> 21 Turbocharger, Supercharger >> Charge Air System >> Charge Air Pressure Sensor -G31-, Removing And Installing >> Removing

Charge Air Pressure Sensor -G31-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S8, 2015 Audi A8 Quattro, 2014 Audi S8, 2014 Audi A8 Quattro, and 2013 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .

WARNING:

Fire hazards and risk of damage for a faulty engine cover.

  • The engine cover must be always be installed before the hood is closed.
  • The engine may neither be started nor driven without an engine cover.

-- Disconnect the connector -2-.

-- Remove the bolts -1-, and remove the Charge Air Pressure Sensor -G31-.

Fig 1: Identifying Charge Air Pressure Sensor Bolts
GWWA21-10729Courtesy of AUDI OF AMERICA, LLC
scientia non olet · About LEMON Manuals