Side marker light bulb, replacing

Fig 1: Identifying Quick-Release Screws And Front Noise Insulation

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing 

• Switch ignition off and remove ignition key.
• Turn light switch into "0" position.
• Remove quick-release screws - 1  - and - 2  - and remove front noise insulation.

Fig 2: Pulling Lamp Socket Off From Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Pull lamp socket - 1  - off from housing for side marker lamp.
• Remove bulb from socket.

Installing 

Installation is performed in reverse order of removal, noting the following:

• Insert new bulb (12V, 5W - orange) into housing, do not touch glass cone with bare hands when doing so.
• When inserting, make sure markings - 2  - and - 3  - are horizontal.