Rear lights - Sedan, assembly
NOTE:
- Illustration shows basic version of rear light.
- Depending on market version, LEDs may be used for brake lights and a 21 W halogen bulb may be used for rear fog lamp.
1 - Housing
- With High version with LEDs for brake light
- Removing and installing → Rear lights / rear light bulb holder, removing and installing
- Align to body contour → Rear lights, aligning with body contour
2 - Light bulb
- For turn signal light
- 12 V, 21 W
- Orange
- Replace → Rear lights / rear light bulb holder, removing and installing
3 - Light bulb
- 12 V, 21 W
- Replace → Rear lights / rear light bulb holder, removing and installing
4 - Light bulb
- 12 V, 21 W
- Replace → Rear lights / rear light bulb holder, removing and installing
5 - Bulb carrier
- Removing and installing → Rear lights / rear light bulb holder, removing and installing
6 - Clip nut
7 - Electrical harness connector
8 - Grommet
9 - Spreader pin
10 - 3.5 Nm
11 - Adjustment nut
- With seal
- To adjust tail lamp to body contour
12 - Threaded bolts
- Bolted in side panel
13 - Light bulb
- 12 V, 21 W
- Replace → Rear lights / rear light bulb holder, removing and installing
14 - Light bulb
- Back-up lamp, Basis version, drivers and passengers side, as well as USA vehicles: 12 V, 21 W
- Rear fog lamp, High version, drivers side: 12 V, 21 W Halogen light bulb
- Back-up lamp, High version, passengers side: 12 V, 21 W
- Replace → Rear lights / rear light bulb holder, removing and installing
15 - Cover