Shock Absorbers, Checking When Removed

Defective shock absorbers are noticeable when driving due to loud rumbling noises - a result of wheel hopping - especially on poor stretches of road. Moreover, they can be recognized by a large loss of oil.

NOTE:

Shock absorbers are maintenance-free, shock absorber oil cannot be topped off.

A Removed Shock Absorber Can Be Checked By Hand As Follows:

-- Press shock absorber together by hand.

Piston rod must move with even resistance throughout entire stroke and without jerking.

-- Release piston rods.

For shock absorbers with sufficient gas pressure, piston rod returns to initial position automatically.

NOTE:

If this is not the case, the shock absorber must be replaced. As long as there is no large loss of oil, the mode of operation corresponds to that of a conventional shock absorber.

The damping function is also completely available without gas pressure, as long as there is no large loss of oil. However, noise may increase.